Let There Be Light Part III

This is part III of a III part series read parts I & II here.

I began working on the light ring stand at about 8:30 pm. It had to be completed that night, for in the morning it was to leave on a cross country drive. If that deadline wasn’t enough, it was also the first night of the newly resurrected #woodchat. Besides making the stand, I was tweeting and Google+ Hangouting for much of the night.To construct the base, I used a 1” thick, factory made sheet of finger jointed pine. I find that using sheets like this for non-decorative pieces is cost effective and the boards I rip from these sheets are much straighter than dimensional lumber would be.

The partially assembled light ring stand.

The entire stand is made from strips, about 2” thick, except for the upper half of each leg. As I ran out of the 1” think sheet and it was 10:30 at night by that point, I used the only dimensional lumber I had in the shop, pieces of 2”x4” Timberstrand to make the tops of the legs. Almost all of the joinery is made using T-nuts, 5/16” threaded rod and plastic knobs for easy breakdown. I set the T-nuts and install short pieces of threaded rod in each, secured with LocTite Threadlocker. Luckily, I had Ari around to cut the threaded rod lenghs for me while I fabricated the stand. The only permanently attached pieces are the receivers for the legs, where are permanently screwed to the feet.

The completed light ring stand with the light ring in place.
The stand is assembled with clamps as the LocTite was not yet dry.

When assembled, the stand is about 7’ high and can hold the light ring, centered at any height from about 3’6” to 6’9”. The light ring is simply placed against the upper legs of the stand and ring’s handles are clamped to the stand using small quick clamps.

To use the light ring, simply stand behind it, and take your photo through the ring, so that your subject is evenly illuminated on every side of the photo.

The stand, broken down and ready for travel.

Broken down, the stand is made of up 9 pieces, none longer than 4’. Though I didn’t have time to do so before the light ring and stand left of the west coast, I told Ari that if I picked up some large Velcro straps, it would make the stand easier to transport.

The light ring is now at home in LA, and its cooking with gas.

The light ring is now in LA, and soon it’ll be illuminating the stars.What odd projects have you made to meet your friend’s needs?

Let There Be Light: Part I

Let There Be Light: Part II